Throttle Position Sensor: Service and Repair

Sensors On Throttle Body:

REMOVAL

Preparation:
- Battery negative cable.

1. Throttle Position (TP) sensor wiring connector
2. TP sensor fixing screw
3. TP sensor

INSTALLATION
3. TP sensor
2. TP sensor fixing screw

Tighten
Fixing screw to 2 Nm (18 lb. in).

Use a "Scan tool" to check TP sensor output voltage with throttle closed, should be under 0.85 volts. If over 0.85 volts, check for binding throttle shaft, or TP sensor lever. If all OK, replace TP sensor.

1. TP sensor wiring connector