Fuel Level Sensor: Service and Repair

REMOVAL

Preparation:
- Disconnect battery ground cable.
- Loosen fuel filler cap.
- Drain fuel.

Tighten
Drain plug after draining fuel.
20 Nm (14 lb. ft) - M8
29 Nm (22 lb. ft) - M14

1. Wiring connector
- Disconnect wiring connector from the unit.
2. Fuel gage unit
- Remove the fixing screws, then the fuel gage unit.

Caution: After removing fuel gauge unit, cover fuel tank to prevent any dust entering

INSTALLATION
2. Fuel gage unit
1. Wiring connector
- Connect the wiring connector to the fuel gage unit.
- Fill the tank with fuel and tighten fuel filler cap.
- Connect battery ground cable.