Powertrain Management: Tools and Equipment

SPECIAL TOOLS




TECH 1
(1) Mass Storage Cartridge
(2) Tech 1
(3) Tech 1 RWAL/4WAL DLC Cable
(4) Cigarette Lighter Power Cable
(5) Tech 114/12 PIN VIM DLC Adapter
(6) Vehicle Interface Module (VIM)
(7) 16/24 Pin VIM DLC Adapter Cable




TECH 1 (SERIES A)
(1) Mass Storage Cartridge or Individual Application Cartridge
(2) Tech 1 (Series A)
(3) Tech 1 (Series A) 14/26 Pin DLC Cable
(4) Vehicle Interface Module (VIM)
(5) 16/24 Pin VIM DLC Adapter Cable
(6) RS-232 Port (Series A only, "Tech 1A")




High Impedance Multimeter (Digital Voltmeter - DVM) J 39200




IAC Motor Analyzer J 37027-A




Unpowered Test Light J 34142-B




Port Fuel Injector Tester J 39021-5V




Connector Test Adapter Kit J 3561 6-A/BT-8637




Spark Tester J 26792/BT-7220-1




Port Fuel Injection Diagnostic Kit J 39021-Box




Vacuum Pump with Gauge J 23738-A




Exhaust Back Pressure Tester BT-851 5-V




Heated Oxygen Sensor Wrench J 39194-B




Terminal Remover J 35689-A




Weather Pack II Terminal Remover J 28742-A




Injector Switch Box J 39021-90




Injector Test Light J 39021-45




EVAP Pressure/Purge Diagnostic Station J 414131
J 41413 EVAP Pressure/Purge Diagnostic Station is a multipurpose tool which is used to perform several diagnostic procedures for enhanced emission testing. The station will accommodate a nitrogen gas filled cylinder which is used to pressurize the vehicle EVAP system for a leak down test and leak location test when a vehicle is repaired for leakage in the enhanced evaporative emission control system. It also has two additional gauges (inches of mercury and inches of water) which are used to measure both source vacuum and EVAP canister purge vacuum to verify correct operation and vapor flow within the canister purge circuit.




Ultrasonic Leak Detector J 414162
J 41416 Ultrasonic Leak Detector is a microprocessor-based device used to detect leaks in the enhanced evaporative emission control system. The evaporative system is pressurized to 30 inches of water using the J 41413 EVAP Pressure/Purge Diagnostic System. Small leaks in the EVAP system will emit sound at a high frequency undetectable by a human ear but detectable with the J 41416. The technician traces along the evaporative system and can pinpoint leaks due to corroded lines, cracked hoses, or a damaged EVAP component. The detector includes a high quality set of headphones to block out surrounding shop noise and the LED sensitivity meter allows a visual reference for locating leaks in conjunction with the audio output heard through the headphones. Powered by (1) nine volt battery.