Engine Replace

REMOVAL

Preparation:
a. Disconnect battery ground cable.
b. Remove engine hood: In order to return the hood to the original position exactly, make alignment on the hood and hinges before removal.
c. Drain radiator coolant.
1. Accelerator cable: Disconnect from throttle valve and common chamber.
2. Ventilation hose
3. Air hose
4. Air cleaner assembly
5. Canister vacuum hose
6. Vacuum booster hose
7. Engine harness connectors
- Disconnect three connectors on canister side.
8. Battery ground cables
- Disconnect two black and white connector clips from the power steering pump bracket.
9. Ground cables
- Disconnect two terminals connected to the battery support and the front right frame.
10. Bonding cable connector
- Disconnect connector on the left side dash panel.
11. Bonding cable terminal
- Disconnect terminal on the back of left bank.
12. Starter harness connector
- Disconnect from starter.
13. Radiator
- Disconnect upper and lower hoses from the engine.
- Disconnect coolant reserve tank hose from radiator.
- Disconnect ATF hose from the pipe. (A/T)
- Remove radiator lower hose clip from the hose bracket.
- Remove radiator lower fan shroud.
- Remove radiator.
14. Power steering pump drive belt
15. Power steering pump
- Remove two bolts on the bracket, and place the pump along with piping on the body side.
16. Air Conditioning compressor drive belt
17. Air Conditioning compressor
- Remove fixing bolts and shift aside the compressor with piping attached.
18. Heater hoses
- Disconnect two hoses from the engine.
19. ATF pipes
- Disconnect two pipes from right side engine mount.
20. Transmission assembly
- See "Transmission Removal and Installation".
21. Left side engine mount
- Support the engine.
- Remove two fixing bolts from engine mount on chassis side.
22. Right side engine mount
- Remove two fixing bolts from engine mount on chassis side.
23. Engine assembly