Arming Sensor
REMOVAL PROCEDURECAUTION: Be very careful when handling the sensors during service procedures. Never strike the sensors. Never jar the sensors. These actions could result in personal injury or improper operation of the Supplemental Restraint System (SRS). Carefully tighten all of the sensors, and all of the mounting bracket bolts to ensure proper operation. Never power up the Supplemental Restraint System (SRS) when any one of the sensors is not rigidly attached to the vehicle. An unattached sensor could be easily activated causing the deployment of the air bag.
Supl Rst Arming Sensor:
1. Disable the Supplemental Restraint System. Refer to Disabling the SRS.
2. Raise the vehicle.
3. Disconnect the Connector Position Assurance (CPA) lock from the retainer.
4. Disconnect the electrical connector.
Supl Rst Arming Sensor:
5. Remove the mounting bolts.
6. Remove the sensor from the vehicle.
Important: Use the following repair procedures when the sensor mounting holes or fasteners are so badly damaged that the sensor may no longer be properly mounted.
Supl Rst Arming Sensor:
First Repair
1. Remove the stripped fastener.
2. Discard the stripped fastener.
3. Enlarge the mounting hole in the sensor to 9 mm (0.350 in).
4. Attach the sensor with the screw and the flanged hex nut.
Tighten
Tighten the screw to 15 N.m (11 lb ft). Refer to Fastener Notice in General Information.
Supl Rst Arming Sensor:
Second Repair
1. Remove the stripped fastener.
2. Discard the stripped fastener.
3. Enlarge the 9 mm mounting hole in the sensor to 11 mm (0.433 in).
4. Enlarge the hole in the frame rail or cross-member to 9 mm (0.350 in).
5. Use the screw to attach the sensor.
Tighten
Tighten the screws to 15 N.m (11 lb ft). Refer to Fastener Notice in General Information.
INSTALLATION PROCEDURE
Supl Rst Arming Sensor:
1. Install the sensor to the vehicle.
2. Install the sensor mounting bolts.
Tighten
Tighten the mounting bolts to 15 N.m (11 lb ft). Refer to Fastener Notice in General Information.
Supl Rst Arming Sensor:
3. Connect the supplemental restraint arming sensor electrical connector.
Supl Rst Arming Sensor:
4. Install the Connector Position Assurance (CPA) lock to the retainer.
5. Remove the safety stands.
6. Lower the vehicle.
7. Enable the Supplemental Restraint System (SRS). Refer to Enabling the SRS