Clearing Trouble Codes

SCS Service Connector:

INDICATION
1. Connect the SCS service connector to the service check connector under the glove box.
2. Turn the ignition switch ON (II), but do not start the engine.
3. Record the blinking frequency of the ABS indicator light. The blinking frequency indicates the Diagnostic Trouble Code (DTC).

NOTE: Check the DTC carefully and record it. The memory of the DTC is erased if the connector is disconnected from the ABS control unit.

4. Remove the SCS service connector.

NOTE: The Malfunction Indicator Lamp (MIL) will stay on after the engine is started if the SCS service connector is connected.

5. Remove the ABS B2 (15 A) fuse in the under-hood ABS fuse/relay box for at least three seconds to erase the ABS control unit's memory.