Rear Suspension

REAR TOE

NOTE: Use commercially-available computerized four wheel alignment equipment to measure wheel alignment (caster, camber, toe and/or turning angle). Follow the equipment manufacturer's instructions.

1. Release parking brake.

NOTE:
- Measure difference in toe measurements with the wheels pointed straight ahead.
- If the parking brake is engaged, you may get an incorrect reading. Rear toe-in: 0 ± 2 mm (0 + 1/16 inch) -0.06 to +0.06 inch.

a. If adjustment is required, go to step 2.
b. If no adjustment is required, remove alignment equipment.





2. Hold the adjusting bolt on the rear lower arm B and loosen the self-locking nut.
3. Adjust the rear toe by turning the adjusting bolt until toe is correct.
4. Install the self-locking nut, and tighten it while holding the adjusting bolt.