Removal

NOTE:
- Before disassembly, jack up the front of vehicle and support frame with jack stands.
- Remove the disc brake caliper assembly and hang it on the frame with wires. Refer to Brakes and Traction Control.





1. Bolt. Before removal, shift transfer lever into "2H" position .
2. Cap
3. Snap Ring and Shim
4. Hub flange
5. Lock Washer and Lock Screw





6. Hub Nut.
- Wrench: J-36827.
7. Hub and Disc Assembly.
8. ABS Sensor Ring (if so equipped).
9. Outer Bearing Outer Race.
10. Oil Seal.
11. Inner Bearing Outer Race.





12. Bolt. If necessary, replace the wheel pin in the following manner:
a. Apply a scribe mark to disc to hub.
b. Clamp the hub and disc assembly in a vise, using protective pads. Remove the 6 disc-to-hub retaining bolts.





13. Wheel Pin. Place hub on a suitable work surface and remove the when studs, as required, using a hammer.

INSPECTION AND REPAIR
Make necessary correction or parts replacement if wear, damage, corrosion or any other abnormal condition are found through inspection. Check the following parts:
- Hub
- Hub bearing oil seal Knuckle spindle
- Disc
- Caliper Shift on the fly system parts (Cap, Hub flange, Shim, Snap ring)
- ABS sensor ring (If so equipped)