Installation

TOOLS REQUIRED
- J-36829 Installer
- J-8092 Grip
- J-36828 Installer
- J-36830 Installer
- Or Equivalent





1. Wheel Pin:
a. Place the hub on a wood workbench or a block of wood approx. 6" by 6" to protect the wheel stud ends and threads.
b. Insert a wheel stud using a hammer. Be sure the wheel stud is started squarely and seats completely.





2. Bolt. Align scribe marks and attach the hub to the disc. Tighten the bolts to 103 Nm (76 ft. lbs.).





3. Inner Bearing Outer Race. Install the outer race: inner bearing by driving it into the hub.
- Installer: J-36829.
- Grip: J-8092.





4. Outer Bearing Outer Race. Install the outer race; outer bearing by driving it into the hub.
- Installer: J-36828.
- Grip: J-8092.





5. Oil Seal. Apply grease (Besco L-2 or equivalent) to the lip portion.
- Installer: J-36830.
- Grip: J-8092.
6. ABS Sensor Ring (if so equipped). Tighten the bolts to the specified torque.
- Torque 18 Nm (13 ft. lbs.).





7. Hub and Disc Assembly:
a. Apply grease in the hub.
b. Apply wheel bearing type grease NLGI No. 2 or equivalent to the other and inner bearing. Grease Amount:
- Hub 35 g (1.23 oz)
- Outer bearing 10 g (0.35 oz)
- Inner bearing 15 g (0.53 oz)





8. Hub Nut. Turn the place where there is a chamfer in the tapped hole to the outer side, and attach the nut. Preload Adjustment:
a. Tighten the hub nut to 29 Nm (22 ft. lbs.), then fully loosen the nut.
- Wrench: J-36827.





b. Tighten the hub nut to the value given below, using a spring scale on the wheel pin. Bearing Preload:
New bearing and New oil seal 20-25 N (4.4 - 5.5 lbs.)
Used bearing and New oil seal 12-18 N (2.6 - 4.0 lbs.)
c. If the measured bearing preload is outside the specifications, adjust it by loosening or tightening the bearing nut.





9. Lock Washer and Lock Screw. Turn the side with larger diameter of the tapered bore to the vehicle outer side, and attach the washer. If the bolt holes in the lock plate are not aligned with the corresponding holes in the nut, reverse the lock plate. If the bolt holes are still out of alignment, turn in the nut just enough to obtain alignment. Screw is to be fastened tightly so its head may come lower than the surface of the washer.
10. Hub flange. Apply adhesive (LOCTITE 515 or equivalent) to both joining faces.





11. Snap Ring and Shim. Adjust the clearance between the hub body and the snap ring.
Clearance 0-0.3 mm (0-0.012 inch)
Shims Available 0.2, 0.3, 0.5, 1.0 mm (0.008, 0.012, 0.020, 0.039 inch)
12. Hub cap.
13. Bolt. Tighten the bolts to the specified torque.
- Torque 59 Nm (43 ft. lbs.).