Disassemble

TOOLS REQUIRED
^ J-37452: Remover
^ J-26941: Remover
^ J-2619-01: Sliding hammer
^ Or Equivalent





1. Filler Plug. Remove filler plug and packing and drain oil.
2. Bolt. Loosen mounting bracket fitting bolts and remove front axle drive shaft from front axle case.
3. Front Axle Drive Shaft (LH side)
4. Bolt. Loosen actuator ASM fitting bolts.
5. Actuator Assembly. Draw out actuator ASM.
6. Bolt. Remove housing fitting bolts.
7. Housing.
8. Sleeve.
9. Clutch Gear.





10. Snap Ring. Remove snap ring from front axle case by using a snap ring plier.
11. Inner Shaft. Take out inner shaft from front axle case.





12. Snap Ring. Remove snap ring from inner shaft by using a snap ring plier.





13. Inner Shaft Bearing. Remove inner shaft bearing by using a special tool and press.
- Remover: J-37452.

NOTE: Be careful not to damage the shaft.





14. Needle Bearing. Remove needle bearing from inner shaft by using a special tool.
- Remover: J-26941.
- Sliding hammer: J-2619-01.

NOTE: Be careful not to damage the shaft.

16. Oil Seal. Remove oil seal from front axle case.

NOTE: Be careful not to damage the front axle case.