Axle Nut

Hub Nut (6)
- Turn the place where there is a chamfer in the tapped hole to the outer side, and attach the nut.

Preload Adjustment





Tighten the hub nut to 29 Nm (22 ft. lbs.), then fully loosen the nut. Tighten the hub nut to the value given below. using a spring scale on the wheel pin.
Bearing Preload:
New bearing and New oil seal: 20 - 25 N (4.4 - 5.5 lbs.).
Used bearing and New oil seal: 12-18 N (2.6- 4.0 lbs.).
If the measured bearing preload is outside the specifications, adjust it by loosening or tightening the bearing nut.