Control Module: Service and Repair

REMOVAL

Preparation: Disconnect negative (-) battery cable.

1. Front console
2. Wiring harness connector
- Disconnect Powertrain Control Module ([1][2]PCM) wiring harness connectors from PCM.





3. [1][2]PCM
- Remove two [1][2]PCM retaining screws.
- Remove two brackets from [1][2]PCM.

INSTALLATION
To install, follow the removal steps in the reverse order.

1. Powertrain Control Module ([1][2]PCM)
- Install two brackets to PCM.
- Install two [1][2]PCM retaining screws.
2. Wiring harness connector
- Connect [1][2]PCM wiring harness connectors to PCM.
3. Front console
- Connect negative (-) battery cable.