Service Procedure
The following procedure applies to both theleft and right side rear passenger seat belts.
1. Remove the plastic cover of the rear shoulder belt's upper attachment point, located on the rear seat belt bar.
2. Remove the upper anchor bolt of the rear shoulder belt.
3. Cut and remove the (thin, black-colored) circular clip washer. (Figure 1)
4. Observe the attachment sequence order of the support washers and the fastening bolt. (Figure 1)
^ The circular clip retaining-washer (from Step 3) is not used during reassembly.
5. Install the new (approx. 10 mm longer at the thread) bolt and torque to 29 lbs. ft (39 N.m.).
6. Re-install the plastic cover.
Repeat Steps 1 through 6 for the remaining side of the rear passenger compartment.
APPLYING THE CAMPAIGN LABEL
1. Using a ball-point pen, fill out the following information on a campaign label (Part # 2-90028-700-0).
^ This safety campaign number: 98V-111
^ Dealer Code
^ Repair Date: (Month/Day/Year)
2. Affix the campaign label adjacent to the manufacturer's identification label located on the drivers side B-pillar.
PARTS INFORMATION
Part Description Quantity
Number Required
2-90028-700-0 Label 1
(Campaign
Label)
897210-026-0 Seat Belt 2
Anchor Bolt
(Shoulder)
WARRANTY CLAIM INFORMATION
Use the new labor operation as shown.
Use Trouble Code 07 for all campaign operations. Labor time includes 0.1 administrative time allowance.
WARRANTY CLAIM SUBMISSION INFORMATION
For your convenience please use the following information when submitting your warranty claim:
LABOR OPERATION 114805
LABOR TIME ALLOWED 0.3
TROUBLE CODE 07
FAILED PART NUMBER 8-97210-026-0