Transmission End Play Check

TRANSMISSION END PLAY CHECK

- Tools Required
- J25022-A End Play Fixture Adapter (245 mm)
- J34725 End Play Fixture Adapter (298 mm)
- J24773-A Oil Pump Remover and End Play Checking Fixture
- J8001 Dial Indicator Set
- J25025-7A Dial Indicator Mounting Post





1. Install an end play fixture adapter.
- Use J25022-A for a 245 mm turbine shaft (1).
- Use J34725 for a 298 mm turbine shaft (2).





2. Install the J24773-A.





3. Remove an oil pump bolt.
4. Install J25025-7A (or a 278 mm or 11 inch bolt) and lock nut.
5. Install J8001.





6. Set the J8001 to zero.
7. Pull up on J24773-A.
8. The end play should be 0.13 - 0.92 mm (0.005 - 0.036 inch).
9. The selective washer (616) which controls the end play, is located between the input housing (621) and the thrust bearing (615) on the oil pump hub. If the dial indicator shows no end play, the selective washer (616) and thrust bearing (615) may have been misassembled.