Automatic 4WD Mode Range Select Switch Bulb Replacement

Four Wheel Drive Select Switch Replacement:

Remove or Disconnect
1. Make sure the headlamp switch is in the OFF position and the ignition switch is in the LOCK position.
2. Transfer case select switch from the instrument panel accessory trim plate. Carefully pry at the edge of the switch with a flat-bladed tool to remove.
3. Electrical connector from the select switch.
4. Bulb(s) from the select switch.

Four Wheel Drive Select Switch Replacement:

Install or Connect
1. Bulb(s) to the select switch.
2. Electrical connector to the select switch.
3. Transfer case select switch to the instrument panel accessory trim plate.