Removal

NOTE: When replacing a speedometer or odometer assembly, federal law requires that the odometer reading of the replacement unit be set to register the same mileage as the prior odometer. If the same mileage cannot be set, the law requires that the replacement odometer be set at zero and a label be installed on the driver's door frame to show the previous odometer reading and the date of replacement.

Important
- All warning lamps use a Light Emitting Diode, (LED). The LED is not serviceable. If a warning lamp's LED stops functioning, the instrument panel cluster must be replaced. The high-beam indicator, turn signal indicators and the dash lights still use an incandescent bulb which is still serviceable.




Remove or Disconnect
1. Battery negative cable. Refer to Battery Disconnect Caution in Cautions and Notes.
2. Instrument panel accessory trim plate. Refer to instrument Panel Accessory Trim Plate Replacement in interior Trim.
3. Instrument panel cluster retaining screws from the instrument panel.
4. Instrument panel wiring harness from the instrument panel cluster.
5. Instrument panel cluster from the instrument panel.




Install or Connect
1. Instrument panel cluster to the instrument panel.
2. Instrument panel wiring harness to the instrument panel cluster.
3. Instrument panel cluster retaining screws to the instrument panel.

Tighten
- instrument panel cluster retaining screws to the instrument panel to 1.9 N.m (17 lb in).

4. Instrument panel accessory trim plate. Refer to instrument Panel Accessory Trim Plate Replacement in interior Trim.
5. Battery negative cable. Refer to Battery Disconnect Caution in Cautions and Notes.

NOTE: For more information on the instrument panel cluster and gauges, refer to instrument Panel Cluster.