Marker Lamp: Service and Repair

Remove or Disconnect
1. Make sure the headlamp switch is in the OFF position and the ignition switch is in the LOCK position.
2. Push down on the side marker lamp locking tab with a flat-bladed screwdriver and pull the lamp assembly outward.
3. Bulb socket from the side marker lamp by rotating it 1/4 turn counter-clockwise.
4. Bulb from the socket by rotating it 1/4 turn counter-clockwise.




Install or Connect
1. Bulb to the socket by rotating it 1/4 turn clockwise.
2. Bulb socket to the side marker lamp by rotating it 1/4 clockwise.
3. Align the side marker lamp and slide it rearward until the locking tab is secure.
- Make sure that the wiring harness does not get pinched during installation of the side marker lamp.