Front
REPLACEMENTTOOL REQUIRED
- 07GAF-SE00100 Hub Dis/Assembly Tool
- 07749-0010000 Driver
- 07746-0010400 Attachment 52 x 55 mm
- 07965-SD90100 Support Base
1. Remove the knuckle from the hub unit. Refer to Steering and Suspension.
2. Remove the splash guard from the knuckle.
NOTE: It is not necessary to remove the splash guard for hub unit or wheel bearing replacement.
3. Separate the wheel bearing from the front hub using the special tools and a press as shown.
CAUTION: Hold onto the hub to keep it from falling when pressed clear.
4. Press the wheel bearing inner race from the hub using the special tools and a bearing separator as shown.
CAUTION: Hold onto the hub to keep it from falling when pressed clear.
5. Replace the bearing with a new one after removal.
NOTE: Wash the knuckle and hub thoroughly in high flash point solvent before reassembly.
6. Press a new wheel bearing into the hub using the special tools and a press as shown.
7. If necessary, install the splash guard and tighten the screws.
NOTE: Align the projection in the splash guard with the hole on the knuckle.
8. Install the knuckle on the hub unit, and tighten the flange bolts. Refer to Steering and Suspension.