Fuse: Service and Repair

SRS component are located in this area. Review the SRS component locations, precautions, and procedures in the SRS section before performing repairs or service.

Removal:
1. Make sure you have the anti-theft code for the radio, then write down the frequencies for the radio's preset buttons.
2. Disconnect the battery negative cable, then disconnect the positive cable, and wait at least three minutes.




3. Remove the dashboard lower cover and knee bolster.
4. Remove the driver's foot rest.

Under-dash Fuse/Relay Box Removal/Installation:

5. Remove the door sill molding, left kick panel, and access panel.

Under-dash Fuse/Relay Box Removal/Installation:

6. Remove the two mounting bolts, and pull the underdash fuse/relay box away from the left kick panel.
7. Disconnect the connectors from the under-dash fuse/relay box, and take out the under-dash fuse/relay box.

NOTE: The SRS main harness connector is a springloaded lock type.

Installation:
1. Connect the connectors to the under-dash fuse/relay box, then install the fuse/relay box in the reverse order of removal.

NOTE: The SRS main harness connector is a springloaded lock type.

2. Connect the battery positive cable and negative cable to the battery.
3. Enter the anti-theft code for the radio, then enter the customer's radio station presets.
4. Confirm that all systems work properly.