Recall - Ignition Switch Inspection/Replacement: Overview
TSB SB02-04-0011997-99 Oasis (VO) Ignition Switch Replacement Safety Recall Campaign 02V-120
ISSUE DATE: JULY, 2002
Campaign Identification Number
Number 02V-120 has been assigned to this campaign. This number will appear on all communications and documentation of any nature dealing with this campaign.
Affected Vehicles
1997-1999 Oasis (VO)
Service Information
Condition:
Honda Motor Co., Ltd, the manufacturer of the Isuzu Oasis, has determined that a certain number of 1997-1999 Oasis vehicles have electrical contacts within the ignition switch that can wear prematurely. This condition can eventually cause the engine to stall without warning. An affected vehicle may experience difficulty in starting for a period of time before experiencing any engine stall. When a stall does occur, the engine can normally be restarted immediately.
Correction:
All affected 1997-1999 Oasis vehicles will have the ignition switch replaced.
NOTE:
Reinstalling aftermarket parts (security systems, alarms, audio systems, etc.) connected to the ignition wiring is not covered under this campaign. If a customer wants a non-OE part reinstalled, the shop that installed the part (or the customer) must do the work and assume liability. In addition the customer is responsible for all costs associated with the non-OE part and its installation.
Dealer Responsibility
Isuzu dealers must service all affected vehicles at no charge to the owner, regardless of mileage, age of vehicle, or ownership.
Whenever a vehicle is affected by this campaign and is in a dealers vehicle inventory, or arrives at a dealership for service, the dealer must take the necessary steps to ensure that this campaign correction has been made before selling or releasing the vehicle.
Owner Notification
American Isuzu Motors Inc. (AIMI) will send a notification letter to owners of affected vehicles already retailed (See Copy). Dealers should follow up with vehicle owners by sending a Campaign Reminder Notice (AIMI SVCF-1052) to all vehicle owners listed in the AIMI Campaign Report AWS 123-1A. Dealers may obtain these postcards from their Regional Office.
Service Procedure
1. Remove the dashboard lower cover, the knee bolster and the steering column covers. See Figure 1
2. Disconnect the ignition switch harness 7P connector from the under-dash fuse/relay box. See Figure 2
3. Note the electrical (Ignition) switch harness routes to the fuse box, you will need to route the new switch harness the same way.
4. Make sure the ignition switch is turned to LOCK (0).
5. Remove the two (2) screws from the electrical switch, then remove and discard the switch and its harness. See Figure 3
6. Install the new electrical switch using the new screws supplied in the parts kit. Route the harness to the fuse box the same way the discarded harness was routed and secure with new lock ties included with kit.
7. Connect the 7P connector.
8. Install the steering column covers, the knee bolster, and the lower dashboard cover.
9. Apply the Isuzu campaign sticker (part # 2-90028-700-0).
Applying the Campaign Label
1. Using a ball-point pen, fill out the following information on a campaign label (Part Number: 2-90028-700-0)
2. Affix the campaign label adjacent to the manufacturers identification label located on the drivers side B-pillar.
Parts Information
Warranty Claim Information
Warranty Claim Submission Information