Installation

WARNING: Lower arm B is under spring pressure. When installing lower arm B, refer to spring installation.

CAUTION:
- Any bolts or nuts connected to rubber mounts or bushings should be tightened with the vehicle on the ground.
- Torque the castle nut to the lower torque specification, then tighten it only far enough to align the slot with the pin hole. Do not align the nut by loosening.
- When removing the knuckle or suspension arms, adjust the load sensing proportioning valve (LSPV) after installing the removed parts.

NOTE:
- Wipe off any oil, dirt or grease from the threads before tightening the fasteners.
- Make sure the toe adjuster cams on lower arm B are installed in the same direction.
- The right and left lower arm B are not interchangeable. Install so the welded nut faces toward the front.
- After installing the suspension arm, check the rear wheel alignment, and adjust if necessary.