ABS - Rear Speed Sensor Resistance Value Revision

BULLETIN NUMBER:
SB97-09-L006

ISSUE DATE:
DECEMBER 1997

GROUP:
BRAKES

1998 RODEO (UE) ABS REAR SPEED SENSOR DIAGNOSIS
(Workshop Manual Revision)

AFFECTED VEHICLES
1998 Rodeo (UE) models.

The rear speed sensor diagnosis procedures, contained in Section 5A - Brake Control System of the following Workshop Manual, have been revised.

Manual Page No.

1998 Rodeo (UE) 5A-24, 47, 50, 54
(Publication No.
UE098-WSM-L01

The nominal resistance values for the rear speed sensor are currently listed as 2.0K to 2.8K ohms. These values should 1.0K to 1.6K ohms. Below is a summary of the revisions to the affected pages:

Page 5A-24 EHCU Connector Pin-Out Checks

^ Step 6, rear speed sensor nominal value changed from 2.0K to 2.8K ohms to 1.0K to 1.6K ohms.

Page 5A-47 Chart B-19 Rear Speed Sensor Open or Shorted (DTC 53 (Flash out)/C0235 (Serial communications)

^ Step 1, changed to read: "Is the resistance between 1.0K and 1.6K ohms?"

^ Step 2, changed to read: "Is the resistance between 1.0K and 1.6K ohms?"

Page 5A-50 Chart B-22 Rear Speed Sensor Missing (DTC 63 (Flash out)/C0236. C0237 (Serial communications)

^ Step 1, changed to read: "Is the resistance between 1.0K and 1.6K ohms?"

^ Step 3, changed to read: "Is the resistance between 1.0K and 1.6K ohms?"

Page 5A-54 Chart C-1-3 Rear Sensor Output Inspection Procedure

^ Step 2, changed to read: "Is the check between connector (F-4) terminals 1 and 2 within 1.0K - 1.6K ohms?"














This Service Bulletin contains the revised pages for the referenced Workshop Manual. Revisions to the affected pages are shown. Attach the enclosed pages to the referenced Workshop Manual pages.