Service Procedure

SERVICE PROCEDURE
(TWO PROCEDURES)

In addition to the warranty extension, the following services are being provided to owners of affected vehicles.

1. BETWEEN 50,000 MILES AND 75,000 MILES
If an affected vehicle comes in for service within that mileage range, inspect the OBD system. Fill out and apply a campaign inspection label. Follow the Workshop Manual procedure to read out any Diagnostic Trouble Codes. If any codes are found, replace the affected part(s). This inspection and any replacement parts are free of charge to the owner.

2. BETWEEN 75,001 MILES AND 150,000 MILES
At this time, the dealer should:
- Again inspect the OBD system and replace any emissions-related component parts(s) that have caused a Diagnostic Trouble Code.
- Replace the distributor cap and rotor, ignition wires, and spark plugs.
- Change the engine oil and oil filter.
- Provide additional information (2nd repair date and mileage) onto the existing 98E-LO1 campaign inspection label, located on the driver's side B-pillar. (If this label does not exist, fill out a new label.)

All of the above services are free of charge to the owner and these services must accompany the use of Genuine Isuzu Parts.

APPLYING THE CAMPAIGN LABEL





In order to signify the completion of each OBD system inspection (during 50,000 75,000 miles AND/OR 75,001 - 150,000 miles), a campaign label must be placed onto the vehicle during the first interval inspection of the OBD system.Additional campaign inspection labels may be obtained from the Isuzu Care Team line at 1-800-643-4070.

BETWEEN 50,000 MILES AND 75,000 MILES

1. Using a ballpoint pen, fill out the following information on a campaign inspection label.

- This service campaign number:
98E-LO1
- Dealer Code
- 1st Inspection Date:
(Month/Day/Year)
- Odometer: (1st Inspection Mileage)

2. Affix the campaign inspection label adjacent to the manuafacturer's identification label located on the driver's side B-pillar.

BETWEEN 75,001 MILES AND 150,000 MILES

1. Using a ballpoint pen, fill out the remaining portion of the existing 98E-LO1 campaign inspection label, located on the driver's side B-pillar.

2nd Inspection Date: (Month/Day/Year)
Odometer: (2nd Inspection Mileage)

NOTE If this label does not exist, fill out a new label.

2. Affix the campaign label adjacent to the manufacturer's identification label located on the driver's side B-pillar.