1. Getting Started

Before operating the Isuzu PCMCIA card with the Tech 2, the following steps must be performed:

1. The Isuzu 98 System PCMCIA card (1) inserts into the Tech 2 (5).
2. Connect the SAE 16/19 adapter (3) to the DLC cable (4).
3. Connect the DLC cable to the Tech 2 (5)
4. Make sure the vehicle ignition is off.




5. Connect the Tech 2 SAE 16/19 adapter to the vehicle DLC.
6. Turn on the vehicle ignition.




7. Power the Tech 2 ON and Verify the Tech 2 power up display.

NOTE: The RS232 Loop back connector is only to use for diagnosis of Tech 2 and refer to user guide of the Tech 2.

Operating Procedure (Part 1 Of 2):

Operating Procedure (Part 1 Of 2):

Operating Procedure (Example)
The power up screen is displayed when you power up the tester with the Isuzu system PCMCIA card. Follow the operating procedure below.