Removal and Installation

Removal Procedure

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.




1. Disconnect the battery negative cable.
2. Recover the refrigerant from the system.
3. Remove the Drive belt.
4. Remove the electrical connectors as necessary.
5. Remove the compressor and condenser hose assembly.
6. Remove the compressor bolts.
7. Remove the compressor rear bracket bolts.
8. Remove the compressor from the brackets.

Installation Procedure




1. Install the compressor into the brackets.

NOTE: Refer to Fastener Note in Service Precautions.

2. Install the compressor rear bracket bolts.

Tighten
Tighten the compressor rear bracket bolts to 31 N.m (37 lb ft).

3. Install the compressor bolts.

Tighten
Tighten the compressor bolts to 50 N.m (37 lb ft).

4. Install the compressor and condenser hose assembly.
5. Install the electrical connectors, if necessary.
6. Install the Drive belt.
7. Connect the battery negative cable.
8. Add refrigerant to the system.
9. Inspect the system for leaks.