Manifold Pressure/Vacuum Sensor: Service and Repair

REMOVAL




1. Remove the electrical connector.




2. Remove the attaching screw (1).
3. Remove the bracket (2).
4. Remove the MAP sensor (3) from the intake manifold (4)

INSTALLATION




1. Install the MAP sensor(3) into the intake manifold (4).
2. Install the MAP Sensor bracket (2).
3. Install the the attaching screw (1).

Tighten
Tighten the attaching screws to 5 N.m (44 lb in).

NOTE: Refer to Fastener Note in Service Precautions.




4. Install the electrical connector.