Clock

1. In order to set the clock display, place the ignition lock cylinder in the ACCESSORY or RUN position The radio may be on or OFF.
2. In order to set the HOUR portion of the clock display, press the SET button. Within 5 seconds, press the SCAN button and hold the button until the correct hour is displayed.
3. In order to set the MINUTE portion of the clock display, press the SET button. Within 5 seconds, press the SEEK button and hold the button in until the correct minute(s) displays. If the SET button is pressed while the radio is turned on, the radio frequency will be displayed. The time of day will display when the SEEK and SCAN buttons are pressed.

When the SET button is pressed, the SET indicator will appear on the display for approximately 5 seconds. If the SCAN or SEEK button is pressed after the SET button is pressed and before the SET indicator goes out, the SET indicator will stay on while the clock is being set and then will go out about 5 seconds after the SCAN or SEEK button has been released.

If electrical power is interrupted (by a blown fuse, discharged or disconnected battery, etc.), reset the clock after power is restored.