T/S CAN. Cam, Upper Bearing Inner Race (Floor Shift)

T/S Can. Cam, Upper Bearing Inner Race (Floor Shift)

Disassembly Procedure

Tools Required

- J 23653-SIR Lock Plate Compressor

Important: Let the SRS coil assembly hang freely after removal.

1. Remove the SRS coil assembly. Refer to On-Vehicle Service; Tilt Column; Inflation Steering Wheel Module Coil (Floor Shift).




2. Compress the shaft lock shield assembly (2) using J 23653-SIR.
3. Remove the bearing retainer (1) from the steering shaft assembly.
4. Discard the bearing retainer (1).
5. Remove J 23653-SIR from the steering shaft assembly.




6. Remove the following parts from the steering shaft assembly:
1. The shaft lock shield assembly (5).
2. The turn signal cancel cam assembly (4).
3. The upper bearing spring (3)
4. The upper bearing inner race seat (2)
5. The inner race (1).

Assembly Procedure

Tools Required

- J 23653-SIR Lock Plate Compressor




1. Lubricate the following parts with synthetic grease.
- The inner race (1).
- The lower brass surface of the turn signal cancel cam assembly (4).
2. Install the following parts onto the steering shaft assembly:
1. The inner race (1).
2. The upper bearing inner race seat (2).
3. The upper bearing spring (3).
4. The turn signal cancel cam assembly (4).
5. The shaft lock shield assembly (5).




3. Compress the shaft lock shield assembly (2) using J 23653-SIR.
4. Install the new bearing retainer (1) onto the steering shaft assembly.
5. Firmly seat the bearing retainer (1) into the groove on the steering shaft assembly.
6. Remove J 23653-SIR from the steering shaft assembly.
7. Install the SRS coil assembly. Refer to On-Vehicle Service; Tilt Column; Inflation Steering Wheel Module Coil (Floor Shift).