Left Hand Side

REMOVAL

1. Disconnect battery ground cable.
2. Remove air cleaner duct assembly.





3. Disconnect O2 sensor connector.





4. Remove exhaust front pipe three stud nuts from exhaust side and two nuts from rear end of exhaust front pipe.
5. Remove heat protector two fixing bolts then the heat protector.
6. Remove a bolt on engine LH side for air conditioner (A/C) compressor bracket and loosen two bolts for A/C compressor then move A/C compressor to front side.
7. Remove exhaust manifold eight fixing nuts and remove exhaust manifold from the engine.

INSTALLATION

1. Install exhaust manifold and tighten exhaust manifold fixing nuts to the specified torque with new nuts.

Torque: 57 Nm (42 ft. lbs.)

2. Install heat protector.





3. Install exhaust front pipe and tighten three stud nuts and two nuts to the specified torque.

Torque:
Stud nuts: 67 Nm (49 ft. lbs.)
Nuts: 43 Nm (32 ft. lbs.)

4. Set A/C compressor to normal position and tighten two bolts and a bolt to the specified torque.

Torque: 40 Nm (30 ft. lbs.)

5. Reconnect O2 sensor connector.
6. Install air cleaner duct assembly.