Rear Door Lock Assembly

Rear Door Lock Assembly and Associated Parts

Removal
1. Disconnect the battery ground cable.
2. Remove rear corner garnish.
3. Remove courtesy light lens.




4. Remove window regulator handle.
- Remove the clip on the rear side of the regulator handle using a wire.
5. Remove the screw while pulling the inside lever toward you and then remove the inside handle.




6. Remove the 2 screws at the pull case and courtesy light.




7. Pull out the trim panel at the 8 clip positions.
- Disconnect the power window switch connector and courtesy light connector.
8. Remove power window switch, it equipped.
9. Remove bracket.
10. Remove waterproof sheet.
- Taking notice of the door harness, peel the waterproof sheet off the door panel carefully.
11. Disconnect the locking links and remove the door lock assembly fixing screws to remove the door lock assembly.

Installation
To install, follow the removal steps in the reverse order, noting the following points.
1. Apply chassis grease to the lock assembly and striker moving surface.




2. Install the regulator handle as shown in the illustration, if equipped without power windows.
3. Check that the door lock operates smoothly.