Front Brake Hose Replacement

REMOVAL
1. Raise the vehicle and support it with suitable safety stands.
2. Remove the wheel and tire assembly.
3. Clean dirt, grease, and other foreign material off the hose fittings at both ends.
4. Disconnect brake pipe.
5. Remove clip.
6. Remove bolt and gasket.
7. Remove hose.

INSTALLATION
To install, follow the removal steps in the reverse order, noting the following points.
1. Tighten the brake pipes to the specified torque

Torque: 16 Nm (12 ft. lbs.)

2. Tighten the bolt to the specified torque.

Torque: 35 Nm (26 ft. lbs.)

NOTE: Always use new gaskets and be sure to put the hooked edge of the flexible hose end into the anti-rotation cavity.

After installing the brake hoses, bleed the brakes.