Rear

REMOVAL
1. Remove rear wheels (1).
2. Remove 2 bolts to remove the caliper assembly (2) from the support bracket. Temporarily hang the caliper with wire etc.
3. Remove rotor (drum) (3).
4. Remove holding spring (4), upper return spring (5) and lower return spring (6).





5. Previously remove the rear cable from the parking brake lever, then remove the brake shoe assembly (7).
6. Remove cable fixing bolt (8) and bolt (9) (10) (11).
7. Remove nut (12).
8. Remove nut (13) and retainer (14).
9. Remove rear cable (15).

INSTALLATION
1. Apply grease (BESCO L-2 or equivalent) to the connecting portion of the rear cable and equalizer. Install rear cable (15).
2. Install retainer (14).
- Tighten nut (13) to the specified torque.

Torque: 41 Nm (30 ft. lbs.)

3. Tighten nut (12) to the specified torque.

Torque 15 Nm (11 ft. lbs.)

4. Tighten bolt (11) (10) (9) to the specified torque.

Torque: 6.5 Nm (57 inch lbs.)

5. Tighten the cable fixing bolt (8) to the specified

Applying Grease To Backing Plate Assembly:

6. Install shoe assembly (7).
After installation of the shoe and cable assembly, apply special grease (included in the repair kit) to the following portions indicated in the figure.





7. Install lower return spring (6) and upper return spring (5).
The parking brake lever side (secondary side) return spring must be installed on the outer side of the primary side return spring.
8. Install holding spring (4).
9. Install rotor (drum) (3).
10. Install caliper assembly (2).
11. Install rear wheels (1).