Transmission Speed Sensor: Service and Repair

REMOVAL

PREPARATION: Disconnect negative (-) battery cable.

1. Front console
2. Selector lever assembly
3. Wiring harness connector. Disconnect speed sensor harness connector from speed sensor.





4. Speed sensor. Remove one 10 mm screw and speed sensor with O-ring.

INSTALLATION

NOTE: To install, follow the removal steps in the reverse order.

1. Speed sensor:
a. Inspect speed sensor O-ring. Replace if necessary.
b. Install speed sensor assembly and 10 mm screw.
- Torque 9 Nm (78 inch lbs.).
2. Wiring harness connector. Connect speed sensor harness connector to speed sensor.
3. Selector lever assembly. Adjust shift lock cable.
4. Front console. Connect negative (-) battery cable.