Rear

REMOVAL
1. Raise the vehicle and support the frame with suitable safety stands.
2. Remove wheel and tire assembly.
3. Remove bolt and nut.
4. Remove link.

CAUTION: Be careful not to damage the ball joint boot.

5. Remove bracket.
6. Remove rubber bushing.

INSPECTION AND REPAIR
Make necessary correction or parts replacement if wear, damage, corrosion or any other abnormal condition are found through inspection. Check the following parts:
- Stabilizer bar
- Rubber bushing
- Link

INSTALLATION
1. Install rubber bushing.
2. Install bracket to axle housing and tighten to the specified torque. Torque to 25 Nm (19 ft. lbs.).
3. Install link.





4. Install bolt and nut, then tighten the nut to the specified torque. Torque to 31 Nm (27 ft. lbs.).