Shifter A/T: Service and Repair

REMOVAL
1. Disconnect battery ground cable.
2. Set ignition Key in "LOCK" position and selector lever in "P" position.
3. Remove transfer control lever knob.





4. Remove lower cluster assembly.





5. Remove rear console.





6. Remove center console.





7. Remove selector lever knob and cover.
8. Disconnect select cable.
9. Disconnect shift lock cable.





10. Remove selector lever subassembly.
11. Disconnect harness connector by pressing down the connector claw in the back of select lever subassembly.

INSTALLATION
1. Install selector lever subassembly.
2. Connect shift lock cable.
3. Connect select cable.





4. Install selector lever knob and cover.
5. Install center console.
6. Install rear console.
7. Install lower cluster assembly.
8. Install transfer control lever knob.
9. Connect harness connector.
10. Connect negative (-) battery cable.
11. After installation, make sure that the selector lever operates normally, and that each selector position is properly indicated. (The red mark shows through the window.)