Interior - Rear Cup Holder Swing Arm Loose
TSB SB02-11-S0041999-2002 Rodeo (UE) Rear Beverage Holder Swing Arm Loose
ISSUE DATE: SEPTEMBER, 2002
Affected Vehicles
1999-2002 Rodeo (UE) equipped with rear beverage holder.
Service Information
Condition:
On affected vehicles, owners may complain that the rear beverage holder swing arm will not stay in an open or closed position because the detents do not hold.
Possible Cause:
One or both of the metal detent clips are out of place or missing.
Correction:
Check for proper installation of both detent clips, if missing, replace detent clip (Part Number: 8-97212-275-0).
Service Procedure
1. With parking brake applied remove the rear console assembly.
2. Remove the two screws inside the console (Figure 1).
3. Pull up the console sides and detach the retaining clips (Figure 2 shown above)
4. Disconnect the power Mode/Winter Mode switch (A/T models only).
5. Remove the ashtray/rear beverage holder assembly from the rear console assembly (Figure 3).
6. Open the beverage holder lid and move the beverage holder swing arm to a position halfway between open and closed.
7. Re-install any loose detent clips securely in place (Figure 4).
8. If a detent clip is missing install a new one (part number: 8-97212-275-0).
Note:
Check to be sure both detent clips are securely installed prior to reassembly of the console.
9. Install the ashtray/beverage holder assembly to the rear of the console.
10. Reinstall the rear console assembly (Note: On A/T models be sure to reconnect the Power Mode/Winter mode switch).
11. Open and close the rear beverage holder swing arm several times to be the detents hold.
Parts Information
Warranty Claim Information
Warranty Claim Submission Information
This Service Bulletin is intended for use by professional, qualified technicians. Attempting repairs or service without the appropriate training, tools, and equipment could cause injury to you or others and damage to your vehicle that may cause it not to operate properly.