Torsion Bar: Service and Repair

REMOVAL
1. Raise the vehicle and support the frame with suitable safety stands.





2. Apply the setting marks (1) to the adjust bolt and end piece, then remove adjust bolt, end piece and seat.





3. Apply the setting marks (2) to the height control arm and torsion bar, then remove height control arm.





4. Apply the setting marks (3) to the torsion bar and lower control arm, then remove torsion bar.

INSPECTION AND REPAIR
Make necessary correction or parts replacement if wear, damage, corrosion or any other abnormal conditions are found through inspection. Check the following parts:
- Torsion bar
- Height control arm
- Adjust bolt
- Rubber seat

INSTALLATION








1. Apply grease to the serrated portions, then install torsion bar. Make sure the bars are on their correct





2. Apply grease to the portion that fits into the bracket then install height control arm and align the setting marks (2).





3. Apply grease to the bolt portion of the end piece (4). Apply grease to the portion of the seat (5) that fits into the bracket.
4. Apply grease to the serrated portions.





5. Install adjust bolt and seat, then turn the adjust bolt to the setting mark (1) applied during disassembly.

NOTE: Adjust the trim height.