Center Link

REMOVAL
1. Remove the speed sensor cable from the center link.
2. Remove the speed sensor cable bracket from the frame.
3. Remove bolt and nut.
4. Remove center link.

INSPECTION AND REPAIR
Make necessary correction or parts replacement if wear, damage, corrosion or any other abnormal conditions are found through inspection.
1. Center link
2. Rubber bushing





- Remove the rubber bushing by using remover J-39214.





- Install the rubber bushing by using to installer J-39214.

NOTE: When mounting rubber bushings, be sure not to use grease on bushings or any other nearby part.

INSTALLATION





1. Install center link. Make sure that the center link is in its correct position.

NOTE: When mounting center link, be sure not to use grease bushings or any other nearby part.

2. Install bolt and nut. Tighten the bolts and nuts lightly, then retighten them to the specified torque after the vehicle is at curb height.

Torque: 137 Nm (101 ft. lbs.)

3. Install speed sensor cable bracket.
4. Install speed sensor cable.