Trailing Link

REMOVAL
1. Remove the parking brake cable from the trailing link.
2. Remove the trailing link fixing bolt and nut.
3. Remove trailing link.

INSPECTION AND REPAIR
Make necessary correction or parts replacement if wear, damage, corrosion or any other abnormal conditions are found through inspection.
1. Trailing link
2. Rubber bushing





- Remove the rubber bushing by using remover J-39214.





- Install the rubber bushing by using installer J-39214.

NOTE: When mounting rubber bushings, be sure not to use grease on bushings or any other nearby part.

INSTALLATION





1. Install trailing link. Make sure that the trailing link is in its correct position.

NOTE: When mounting trailing link, be sure not to use grease on bushings or any other nearby part.

2. install bolt and nut. Tighten the bolts and nuts lightly, then retighten them to the specified torque after the vehicle is at curb height.

Torque: 137 Nm (101 ft. lbs.)

3. Install parking brake cable.

CAUTION: The parking brake cable should not be overstrained or slackened.