Interior Trim Cover and Assist Grip

Interior Trim Cover, Assist Grip and Associated Parts

Removal
1. Disconnect the battery ground cable.
2. Remove the sill plate.
Remove the clip and four fixing screws.
3. Pull out the front door finisher.
4. Remove the front pillar trim cover.
Pry the two retainers free from the body panel and then pull front pillar trim cover upward.




5. Remove the assist grip (1).
Move the covers (2) and remove the two fixing screws.
6. Remove the front seat belt anchor bolts.
Remove the upper anchor bolt and the lower anchor bolt.




7. Remove the quarter trim cover.
- Remove the fixing screw and pry the trim cover clips (1) free from the body panel.
- Peel off the trim cover at the adhesive tape (2) and velcro fasteners (3).
8. Remove the rear seat belt anchor bolts.
Remove the upper anchor bolt and the lower anchor bolt.
9. Remove the tailgate weather strip.
10. Remove the rear roof trim cover.
Pry the trim cover retainers free from the body panel.
11. Remove the luggage rear trim cover.
Remove the four screws.




12. Remove the luggage side trim cover.
- Remove the five fixing screws.
- Pry the trim cover clips (1) free from the body panel.
- Remove the two clips (RH side).

Installation
To install, follow the removal steps in the reverse order, noting the following points:
1. Tighten the front seat belt upper anchor bolt to the specified torque.
Torque: 49 Nm (36 lb.ft)
2. Tighten the front seat belt lower anchor bolt and rear seat belt anchor bolts to the specified torque.
Torque: 39 Nm (29 lb.ft)