Door Lock Cylinder: Service and Repair

Removal
1. Disconnect the battery ground cable.
2. Remove the door trim assembly.
3. Remove the waterproof sheet.
Take notice of the door harness and the grommet, peel the waterproof sheet off the door panel carefully.
4. Remove the Grommet.




5. Remove the outside handle.
- Remove the two fixing bolts.
- Disconnect the locking links (1).




6. Remove the fixing clip (1) to remove the door lock cylinder (2).




7. Remove the door lock cylinder switch harness (2) (driver's side only).
- Disconnect the connector (4).
- Remove the three clips (3) from door panel and rear guide rail (1).

Installation
To install, follow the removal steps in the reverse order, noting the following points:
1. When installing the door lock cylinder switch harness, pass through the back of rear guide rail.
2. Tighten the outside handle fixing bolts to the specified torque.
Torque: 9 Nm (78 lb.in)
3. Check for smooth outside handle and lock cylinder operation.