Headlamp: Adjustments
PreparationPlace the vehicle with 1 - person in driver seat, on a level surface and check to see if the inflation pressure of the tires is correct, the lenses are clean, the battery is sufficiently charged, and adjust to place vehicle by using the screen.
1. Set up the screen (1) on a level surface.
2. Put on the screen at right angles to the center line (3).
3. Adjust the center of the vehicle (2) to the center line on floor.
4. Keep the vehicle (2) 3 m (9.8 ft) apart from the screen (1).
5. Toward the screen from the bulb center mark of headlight, extend a parallel line (A) to the floor and draw a vertical line (V) at an intersection point of screen and a parallel line (A).
6. Measure a height (H) from the bulb mark of headlight to the floor and draw a horizontal line on the screen.
7. Turn on the low beam of headlight.
8. Adjust the bending point to the vertical line (V) by horizontal adjustment and adjust cut line 21 mm (0.83 in) below from horizontal line (H) by vertical adjustment.
Horizontal Adjustment
Inserting the spacer (6) between headlight assembly (4) and deflector panel (5), adjust the horizontal aiming of headlight.
Vertical Adjustment
Use a screwdriver for vertical and horizontal adjustment.