Removal and Installation

Removal




1. Disconnect battery ground cable.
2. Move drive belt tensioner to loose side using wrench then remove drive belt (1).
3. Disconnect the wire from terminal "B" and disconnect the connector (4).
4. Remove generator fixing bolt (3).
5. Remove generator assembly (2).

Installation
To install, follow the removal steps in the reverse order, noting the following points:
1. Install generator assembly to the position to be installed.
2. Install generator assembly and tighten the fixing bolts to the specified torque.
Torque:
M10 bolt: 41 Nm (30 lb.ft)
M8 bolt: 21 Nm (15 lb.ft)
3. Connect wiring harness connector and direct terminal "B".
4. Move drive belt tensioner to loose side using wrench, then install drive belt to normal position
5. Reconnect battery ground cable.