Removal and Installation
Removal1. Disconnect battery ground cable.
2. Disconnect Heated Heated Oxygen (O2) Sensor connectors (1).
3. Remove exhaust front left pipe (2).
4. Remove heat protector (3).
5. Disconnect starter wiring connector from terminals "B" and "S" (4).
6. Remove starter assembly mounting bolts on inside and outside (5).
7. Remove starter assembly toward the bottom of engine (6).
Installation
To install, follow the removal steps in the reverse order, noting the following points:
1. Install starter assembly (6).
2. Install mounting bolts and tighten bolts to specified torque (5).
Torque: 40 Nm (30 lb.ft)
3. Reconnect the connectors to terminals "B" and "S" and tighten Terminals "B" to specified torque.
Torque: 9 Nm (80 lb.in)
4. Install heat protector (3).
5. Install exhaust front left pipe and tighten bolts and nuts to specified torque (2).
Stud Nuts - Torque: 67 Nm (49 lb.ft)
Nuts - Torque: 43 Nm (32 lb.ft)
1. Connect O2 Sensor connectors (1).
2. Reconnect the battery ground cable.