Extension Housing
DISASSEMBLED VIEW
DISASSEMBLY
1. Remove the vent (1) from the extension housing (4).
2. Remove the slip yoke seal (2) from the rear of the extension housing (4), using remover J-26941and slide hammer J-23907.
3. Remove the slip yoke bushing (3) from the rear of the extension housing (4), using remover J-23062-14 and driver handle J-8092.
REASSEMBLY
1. Install the slip yoke bushing (3) into the rear of the extension housing (4), using installer J-23062-14 (with J-8092 driver handle) and a hammer.
2. Install the slip yoke seal (2) into the rear of the extension housing (4), using installer J-38763 and a soft-faced hammer.
3. Install the vent (1) into the extension housing.