Operation CHARM: Car repair manuals for everyone.

Input Bearing Retainer





DISASSEMBLED VIEW

DISASSEMBLY





If you have not done so previously, remove these parts from the input bearing retainer (1):
- Bearing outer race (4)
- Shim (s) (3)





1. Remove the input shaft seal (2), using Input seal remover J-29369-2 and slide hammer J-23907.

REASSEMBLY





1. Install the input shaft seal (2) in the retainer (1), using the installer J-37375 and a soft-faced hammer.
2. Install the input bearing outer race (4) in the retainer (1) without the shim (3) behind it.