Column Shift

Disassembly Procedure
1. Remove the upper and lower shrouds.





2. Remove the wire harness assembly (1) from the wire harness strap (2) and the steering column.





3. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly out of the bulkhead connector (1).





4. Rotate the key alarm connector (1) 90 degrees.
5. Pull the key alarm connector (1) out of the lock module assembly (2).
6. Remove the passkey connector from the lock module assembly (2).





7. Slide the ignition and key alarm switch assembly (2) out of the lock module assembly (1) by releasing the tabs.


Assembly Procedure





1. Slide the ignition and key alarm switch assembly (3) into the lock module assembly (1).





Push the key alarm connector (1) into the lock module assembly (2).
2. Rotate the key alarm connector (1) 90 degrees so that the key alarm connector (1) locks into place.
3. Install the passkey connector into the lock module assembly (2).





4. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly into the bulkhead connector (1).





5. Attach the wire harness assembly (1) to the steering column with new wire harness strap (2).
6. Install the upper and lower shrouds.