Steering Column Bracket

Removal Procedure

IMPORTANT: The upper steering column support bracket is not serviceable.

1. Remove the instrument panel. Refer to IP Carrier Replacement.
2. Remove the brake switch. Refer to Stoplamp Switch Replacement in Hydraulic Brakes.
3. Remove the brake booster pushrod from the brake pedal. Refer to Vacuum Brake Booster Replacement in Hydraulic Brakes.




4. Remove the clutch master cylinder pushrod from the clutch pedal. Refer to Clutch Pedal Replacement in Clutch.
5. Remove the following steering column support bracket fasteners:
- The 4 flange nuts
- The 2 bolts
6. Remove the brake pedal from the upper steering column support bracket. Refer to Brake Pedal Replacement in Hydraulic Brakes.

Installation Procedure




1. Install the brake pedal to the upper steering column bracket. Refer to Brake Pedal Replacement in Hydraulic Brakes.

NOTE: Refer to Fastener Note in Service Precautions.

2. Install the upper steering column support bracket fasteners.

Tighten
Tighten the nuts to 25 N.m (18 lb ft).
Tighten the bolts to 25 N.m (18 lb ft).

3. Install the brake switch. Refer to Stoplamp Switch Replacement in Hydraulic Brakes.
4. Install the clutch master cylinder pushrod from the clutch pedal. Refer to Clutch Pedal Replacement in Clutch.
5. Install the brake booster pushrod to the brake pedal. Refer to Vacuum Brake Booster Replacement in Hydraulic Brakes.
6. Install the instrument panel. Refer to IP Carrier Replacement.