Seal Replacement - Hood Rear

Removal Procedure
1. Remove the cowl plenum screws.
2. Use a flat-bladed tool in order to carefully break the adhesive bond.
3. Remove the seal assembly from the cowl plenum flange.
4. Clean the flange. Use a suitable solvent such as a mixture of 50 percent isopropyl alcohol and 50 percent water or high-flash naptha.
5. Dry the area thoroughly.




Installation Procedure
1. Remove the liner from the adhesive strip.
2. Position the seal.
3. Press the seal into place.

NOTE: Refer to Fastener Note in Cautions and Notes.

4. Install two screws to secure the seal to the cowl. Tighten the screws until fully seated but not stripped.