Oil Pressure Sender: Service and Repair

Removal Procedure

^ Tools Required
- J41712 Oil Pressure Switch Socket

1. Raise the vehicle.
2. Remove the right fender wheelhouse extension.





3. Disconnect the engine oil pressure gauge sensor electrical connector (2).





4. Using the J41712 remove the engine oil pressure gauge sensor.

Installation Procedure

^ Tools Required
- J41712 Oil Pressure Switch Socket





1. Install the engine oil pressure gauge sensor using the J41712.
Tighten to 12 Nm (106 inch lbs.).





2. Connect the engine oil pressure gauge sensor electrical connector (2).
3. Install the right fender wheelhouse extension.
4. Lower the vehicle.